A good leak detector is a big investment and one of the more important tools a tech has on the truck. I’ve had the same leak detector for years and I’ve replaced everything on it from sensors to pumps to the probe.

One thing that I have learned is that with leak detectors care, maintenance, and testing is a huge part of finding leaks the first time. It will also save you a lot of money. This little tutorial covers the Bacharach H10 series but many of the tips apply to most detectors.

Keep it Clean and Dry

Leak detectors don’t like moisture and dirt. Make sure to keep the rubber tip and filter on the end to help prevent creating a seal that pulls in moisture and keep the detector off the floor and out of the dirt. If you ever do get your detector wet, shut it off quickly, pull out the batteries (if it has them), and put them in a degassing chamber and pull a vacuum on it. This will dehydrate the detector and can often save it.

Store it in a Safe Place

Leak detectors have sensitive pumps and sensors in them that can be damaged if they are handled roughly. Also, keep from kinking the hoses or probes as this can cause leaks in the tube that will impact your reading as well as restrict flow to the sensor.

Confirm Flow

The H10 series of leak detectors has a red ball flow indicator in the probe. The first thing I do when I start the detector and allow it to warm up is to check the flow through the probe by pointing it down and seeing is the red ball floats.

Check your Sensor

Make sure your sensor is properly connected and on the H10 you can physically feel the heat from the sensor guard door when the unit is running.

Adjust the Sensor

On the H10 you can use the adjustment on the bottom to increase the current through the sensor as it ages to maintain performance. Make sure to adjust it back to the starting point when you install a new sensor to extend the life of the sensor.

Use a Reference Leak

I see many techs attempt to use a bit of refrigerant out of a tank to test their leak detector. With most detectors having a published leak detection accuracy of 0.10 ounces per year, this is a really rough way to test a detector. The best way is to use a tiny calibrated leak or a leak reference bottle like the one shown above to ensure that your detector is going to find small leaks as well as large ones.

If you treat your detector well and confirm the operation of it every time you use it, you should get great results and a long life.

Publication date: 5/27/2019

Want more HVAC industry news and information? Join The NEWS on Facebook, Twitter, and LinkedIn today!