The compressor's discharge temperature is often an overlooked temperature when troubleshooting a refrigeration or A/C system. However, it's very important because it's an indication of the amount of heat absorbed in the evaporator and suction line, and any heat of compression generated by the compression process.
This article describes how to troubleshoot a compressor and the associated problems that can cause a system to fail prematurely. It discusses the proper methods of diagnosing and repairing system problems.
In this installment of the Btu Buddy series, Bob services an oil furnace and discovers a plugged up oil filter. Btu Buddy explains the cause of the problem and assists him in correcting it.
The next time you're faced with replacing an old steam boiler that was attached to a two-pipe air vent system, try the old-timer's trick. Remember that the replacement boiler is smaller in size and holds less water, thus requiring a boiler feed tank that acts as a reservoir for the new boiler.
In this edition of the Btu Buddy series, the dispatcher calls Bob and tells him a customer has a very frozen heat pump outdoor coil. After checking out the unit, Bob finds a bad fan capacitor.
This article is the third and final part of a three-part series on inspecting and servicing gas appliances. It provides information on furnace operation, combustion analysis, and the limit circuit.
Soldering is a viable method of joining ACR tubing and components while servicing and installing refrigeration systems. However, not all types of solders can be used satisfactorily.
In this installment of the Btu Buddy series, Bob goes on a call where a carbon monoxide detector alarm is sounding off. He finds that a fireplace is contributing to the problem.
This article is part two of a three-part series on inspecting and servicing gas appliances. It covers thermostats/zone sensors, filters, the blower compartment, wiring, and the burner compartment.
This article is part one of a three-part series on inspecting and servicing gas appliances. This part covers infiltration air and the ventilation air test, equipment efficiency, venting, and the three-part testing procedure for checking a heat exchanger.